HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 67 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
5EChange the parameter to a
path where the High Speed
The selection of High Speed
mode/MIX mode is invalid.
12018105
mode/MIX mode can be set,
and then retry the operation.
The specified port cannot be
changed to High Speed
mode/MIX mode.
6EThe configuration information
has been already changed.
High Speed mode/MIX mode
was specified. However,
12038105
Check the settings, and
request the setting of the
there are addresses to which
High Speed mode/MIX mode
cannot be set in the Fibre
configuration information
again.
Addresses of the specified
ports.
6EThe configuration information
has been already changed.
High Speed mode/MIX mode
was specified. However,
12048105
Check the settings, and
request the setting of the
there are topologies to which
High Speed mode/MIX mode
cannot be set in the
configuration information
again.
topologies of the specified
ports.
6EThe port you are trying to set
is for XP Continuous Access.
Add path to the initiator port
failed.
13508105
You must change the attribute
(Target or RCU Target) when
adding a path.
6ECannot set to high-speed
mode because the port
The high-speed or
initiator/external mix mode
13518105
attributes are mixed, orcannot be set to the specified
cannot set toport because of the attribute
of the port. internal/external mix mode
because the combination of
port attributes is different.
Check the port attributes, and
then retry the operation.
6EBecause the port you are
trying to set is for XP
Logical paths remain on the
Fibre-MCU port. This
13528105
Continuous Access, you mustoperation may cause a fatal
delete the logical path, and
then retry the port setting.
damage to the logical paths.
Please stop this operation. If
you want to continue this
operation, please remove the
logical paths from the MCU
port first.
6EBecause the port you are
trying to set is for XP
S-VOLs remain on the
Fibre-RCU port. This
13538105
Continuous Access, you mustoperation may cause a fatal
delete the S-VOL logical pathdamage to S-VOLs. Please
that is set to RCU Target, and
then retry the port setting.
stop this operation. If you
want to continue this
operation, please remove the
S-VOLs from the RCU port
first.
6EThe port you are trying to set
is for XP Continuous Access.
Failed to add the WWN to
the initiator port.
13548105
You must change the attribute
(Target or RCU Target) when
adding a WWN.
388 Remote Web Console for Storage System Messages and Error Codes