HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 67 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
error occurs, contact HP
technical support.
enable command device
security on the volume.
6EThe configuration information
has been already changed.
There are no host groups
where the WWN will be
registered.
11258105
Check the settings, and
request the setting of the
configuration information
again.
5ECorrect the specified
contents, and request again.
A volume set as a command
device cannot be used as a
11268105
component of a LUSE volume.
Select another volume.
2ECHA high-speed mode is
specified to an unmounted
An error occurred. If this
problem persists, call HP
technical support.
11278105
CHA. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
2EA request has been made to
change to a channel speed
An error occurred. If this
problem persists, call HP
technical support.
11288105
change is requested, but
Fibre PCB does not support
it. The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
6ECorrect the specified
contents, and request again.
The specified name is the
same as the system default
name. Change the name.
11308105
6EThe configuration information
has been already changed.
Failed to set the host group
because the number of host
11318105
Check the settings, and
request the setting of the
groups exceeds the maximum
that can be set in a port.
configuration information
again.
6EThe configuration information
has been already changed.
Failed to set the WWN
because the number of
11328105
Check the settings, and
request the setting of the
WWNs exceeds the
maximum that can be set in
a port.
configuration information
again.
6EThe configuration information
has been already changed.
Failed to set the host mode
because the number of host
11338105
Check the settings, and
request the setting of the
modes exceeds the maximum
that can be set in a port.
configuration information
again.
6EThe configuration information
has been already changed.
Failed to set the path because
the number of paths exceeds
11348105
386 Remote Web Console for Storage System Messages and Error Codes