HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 67 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
requested for volumes other
than open volumes (including
change the command device
configurations:
uninstalled volumes). The
• Volumes reserved by Auto
LUN
error does not occur normally
because it is guarded in the
• Volumes other than the
open-system volumes
screen. In the unlikely event
that this error occurs, contact
HP technical support.
(including unmounted
volumes)
• System Disk volume
5WRemove the prohibited
characters from the
nickname.
You cannot use following
characters for the name:
" \ / : , ; * ? < > |
11108105
You cannot use spaces for the
first and the last characters in
the name.
2EA nickname is not specified
when the configuration
An error occurred. If this
problem persists, call HP
technical support.
11118105
change of LUN-Security is
requested. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
2EYou have not specified the
value when registering
An error occurred. If this
problem persists, call HP
technical support.
11168105
WWN, or zero is set as the
WWN value. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
6EThe configuration information
has been already changed.
Command device security
cannot be set to the specified
11238105
Check the settings, and
request the setting of the
volume because the volume
is not a command device.
configuration information
again.
2EThe setting method of
command device/command
An error occurred. If this
problem persists, call HP
technical support.
11248105
device security is incorrect.
The command device setting
and the command device
The following settings are
invalid.
1. Set command device +
Release command device
security
security setting are incorrect.
You cannot do any of the
following to the same volume:
2. Release command device
+ Set command device
security
• Specify the volume as a
command device and
disable command device
security on the volume.
The error does not occur
normally because it cannot
• Specify the volume as a
non-command device and
be modified in the window.
In the unlikely event that this
Remote Web Console Error Codes 385