HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 64 Error Codes — Part Code 7105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iCheck the contents, and retry.The SSID is invalid.86517105
0iCheck the target volume
number.
The boot device is not an
S-VOL nor T-VOL.
86527105
0iCheck the target volume
number.
Because the boot device is
the S-VOL in the DeletePair
86537105
command, the flag does not
match.
0iCheck the target volume
number.
The boot device and the
T-VOL do not match in the
86547105
AddPair, Resync, or
DeletePair command.
0iCheck the contents, and retry.An invalid secondary SSID is
specified for the AddPair or
Resync command.
86557105
0iCheck the contents, and retry.An invalid secondary SSID is
specified for the Delete Pair
or Split Pair command.
86567105
5ECall HP technical support.The Swap&Freeze option
cannot be specified, because
mode 80 is on.
86577105
0iRelease the relationship to
delete the FlashCopy
The command has been
rejected, because the
86967105
Mirroring V2 pair, or specify
another volume.
specified S-VOL is being used
as the T-VOL of a FlashCopy
Mirroring V2 pair.
0iRelease the relationship to
delete the FlashCopy
The command has been
rejected, because the
86977105
Mirroring V2 pair, or specify
another volume.
specified T-VOL is being used
as the volume of a FlashCopy
Mirroring V2 pair.
0iRelease the relationship to
delete the FlashCopy
The command has been
rejected, because the
86987105
Mirroring V2 pair, or specify
another volume.
specified volume is being
used as the volume of a
FlashCopy Mirroring V2 pair.
0iRelease the relationship to
delete the FlashCopy
Mirroring V2 pair.
The Reverse Copy or Quick
Restore command has been
rejected, because the
86997105
specified S-VOL is also being
used as the volume of a
FlashCopy Mirroring V2 pair.
0iWait for Flash Copy
processing of a L1 pair being
Because a L1 pair is F-Copy,
you cannot operate to L2.
89207105
finished, and then execute
operation of target pair.
0iCorrect the specified CT
Group and retry the
operation again.
The command was rejected
because the specified CT
Group is already used.
89417105
0iInstall the appropriate version
of DKC microcode.
The CT Group operation is
not available because the
89427105
target DKC microprogram
366 Remote Web Console for Storage System Messages and Error Codes