HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 58 Error Codes — Part Code 6610 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
subsystems and then retry the
operation.
0iThere are no consistency
groups available. Create
There are no consistency
groups available. Create
565226610
unused consistency groups,
and then retry the operation.
unused consistency groups
and then retry the operation.
0iCheck the mirrors of the
specified volume.
No more mirrors can be
created for the specified
volume.
565236610
0iCheck the error information.An error occurred. Check the
error details.
590046610
0iSpecify the valid value.An invalid value is specified.590056610
0iCheck the number of journal
volumes in the specified
No more journal volumes can
be registered, or too many
volumes are selected.
590066610
journal group, or check the
number of the selected
volumes.
0iTo delete the specified
storage system, click [OK].
Otherwise, click [Cancel].
Are you sure you want to
delete the specified
subsystems?
590076610
0iTo delete the specified path,
click [OK]. Otherwise, click
[Cancel].
Are you sure you want to
delete the paths of the
specified subsystem?
590086610
0iClick [OK]. Apply the
Preview data to the disk
Since the number of Preview
data exceeded the maximum,
590096610
storage system, and then
retry the operation.
the excess data were
discarded. No more Preview
data can be stored.
0WCheck the contents of the
primary and secondary
WARNING:
Initial copy mode None is
selected for some volume
590106610
volumes. If the contents
match, click [Yes]. Otherwise,
click [No].
pair. Are you sure that the
primary data volume and the
secondary data volume of the
pair are already
synchronized?
0iTo output the file, click [Yes].
Otherwise, click [No].
Are you sure you want to
output the %s file?
590116610
0WTo overwrite the file, click
[Yes]. Otherwise, click [No].
The specified file already
exists. Do you want to
overwrite this file?
590136610
0WCheck the DKC setting.The same DKC is specified
more than once. Check the
DKC setting.
590266610
5iTo continue the operation,
click [OK]. To cancel the
operation, click [Cancel].
The monitoring data saved at
present will be deleted.
590306610
The current monitoring data
will be deleted if you change
the setting of the monitoring
switch. If necessary, use the
Remote Web Console Error Codes 323