HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 56 Error Codes — Part Code 6510 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iCheck the number of journal
volumes in the specified
No more journal volumes can
be registered, or too many
volumes are selected.
590066510
journal group, or check the
number of the selected
volumes.
0iTo delete the specified
storage system, click [OK].
Otherwise, click [Cancel].
Are you sure you want to
delete the specified
subsystems?
590076510
0iTo delete the specified path,
click [OK]. Otherwise, click
[Cancel].
Are you sure you want to
delete the paths of the
specified subsystem?
590086510
0iClick [OK]. Apply the
Preview data to the disk
Since the number of Preview
data exceeded the maximum,
590096510
storage system, and then
retry the operation.
the excess data were
discarded. No more Preview
data can be stored.
0WCheck the contents of the
primary and secondary
WARNING:
Initial copy mode None is
selected for some volume
590106510
volumes. If the contents
match, click [Yes]. Otherwise,
click [No].
pair. Are you sure that the
primary data volume and the
secondary data volume of the
pair are already
synchronized?
0iTo output the file, click [Yes].
Otherwise, click [No].
Are you sure you want to
output the %s file?
590116510
0WTo overwrite the file, click
[Yes]. Otherwise, click [No].
The specified file already
exists. Do you want to
overwrite this file?
590136510
0WCheck the DKC setting.The same DKC is specified
more than once. Check the
DKC setting.
590266510
5iTo continue the operation,
click [OK]. To cancel the
operation, click [Cancel].
The monitoring data saved at
present will be deleted.
590306510
The current monitoring data
will be deleted if you change
the setting of the monitoring
switch. If necessary, use the
Performance Monitor Export
Tool to export the monitoring
data file.
5iTo continue processing, click
[OK]. To stop processing,
click [Cancel].
The monitoring data saved at
present will be deleted when
the monitoring switch is set to
Enable the next time.
590316510
The monitoring data currently
saved will be deleted when
you change the setting of the
monitoring switch. If
necessary, use the Export
Tool to save the monitoring
data.
Remote Web Console Error Codes 313