HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 56 Error Codes — Part Code 6510 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iClick [OK], and then specify
the correct volume.
The specified volume was not
found.
91286510
0iClick [OK].The history file has been
updated. Select the OK
91556510
button to display the history
logs from the beginning.
0WCheck the device emulation
or the definition of the SCSI
path.
There are no valid volumes.93036510
0WSet the port to Initiator before
registering the storage
system.
There are no initiator ports.93056510
5WObtain a license for XP
Continuous Access Journal,
and then install it.
The XP Continuous Access
Journal function is not
installed in this controller.
You cannot create pairs.
93066510
0WBecause there are duplicated
paths in the added paths, the
You set the same path more
than once. The duplicate
paths are excluded.
93086510
duplicated paths will be
eliminated. Click [OK] to
continue.
0WBecause all the added paths
are redundant, the paths
All paths which you set have
already been registered. This
93096510
cannot be added. Click [OK]
and continue.
operation will terminate
because there is no path
which can be added.
0iClick [Refresh] to update the
history file. If this problem
The monitoring time is over,
but the history file is not fully
updated yet.
93276510
persists, call HP technical
support.
0iClick [OK], and then continue
the operation.
This operation is not applied
yet.
93326510
0iCheck the number of data
volumes in the journal group.
Too many data volumes in
the journal group.
550366510
Then delete unused data
volume pairs, or register them
in another journal group.
0iCheck the number of mirrors
in the journal group. Then
Too many mirrors in the
journal group.
550376510
delete unused mirrors, or
register them in another
journal group.
0iCheck the number of mirrors
in the journal group, and
then delete unused mirrors.
Too many mirrors in the
subsystem.
550386510
0iCheck the range setting. If
you specify Group, select
You are specifying Group for
the range and trying to
550396510
only one data volume pair in
the mirror.
manipulate the same mirror.
Select only one data volume
pair in the mirror when you
specify Group for the range.
Remote Web Console Error Codes 311