HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 56 Error Codes — Part Code 6510 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2ECall HP technical support.An error occurred in client
logic.
73026510
2ECall HP technical support.An error occurred in client
logic.
73036510
2EIf the error occurs after
retrying, call HP technical
support.
An error occurred during
processing. If this problem
persists, call HP technical
support.
74406510
5WClick [Refresh], and retry.The system cannot apply the
new configuration. Do you
want to refresh?
81016510
5WCheck the port type, and then
change cable connections.
Exchange the channel cable
connections after
confirmation of the port type.
90066510
0iClick [OK].The export is complete.90096510
5WTo continue processing, click
[Yes]. If the processing
The Port Setting process has
not completed. Do you want
to continue for other ports?
90216510
finishes, reconfigure the port
that is not in operation.
5WEnsure that the associated
channel paths are offline.
Are you sure you want to
exchange the specified ports?
90246510
Confirm the associated
channel paths are off-line.
5WRemove the remote copy
paths that are associated with
the ports.
Are you sure you want to
switch the ports? If the remote
copy paths exist on the ports,
delete them beforehand.
90256510
5WTo continue to change ports,
click [OK].
Are you sure you want to
switch the ports?
90266510
If any remote copy paths exist
on the ports, delete them
beforehand.
Also, to avoid the switching
operation from being
reported as a failure, confirm
first that a message
prompting you to change the
channel cable connections is
displayed, and then perform
the necessary changes.
0iTo close the window, click
[OK]. Otherwise, click
[Cancel].
Do you want to exit?91006510
0iTo cancel the operation, click
[OK].
Do you want to cancel?91016510
0iTo apply settings in Preview
to the disk storage system,
click [OK].
Do you want to apply?91026510
0iTo switch the mode, click
[OK]. Otherwise, click
[Cancel].
Do you want to change the
mode?
91046510
Remote Web Console Error Codes 309