HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 54 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
If this problem persists, call
HP technical support and
request to format the volume.
0WConfirm that the shredding
has completed in the Data
The Add Pair (Paircreate)
operation failed because the
585646505
Retention Utility window, and
then retry the operation.
specified primary data
volume is being shredded by
Data Retention Utility.
Retry the operation after the
shredding is completed.
0WConfirm that the shredding
has completed in the Data
The Add Pair (Paircreate)
operation failed because the
585656505
Retention Utility window, and
then retry the operation.
specified secondary data
volume is being shredded by
Data Retention Utility. Retry
the operation after the
shredding is completed.
0WConfirm that the shredding
has completed in the Data
The specified volume cannot
be registered as a journal
585666505
Retention Utility window, and
then retry the operation.
volume because the volume
is being shredded by Data
Retention Utility.
Retry the operation after the
shredding is completed.
0WCheck the status of the
journal volumes of the
The Add Pair (Paircreate)
operation or the Resume Pair
585906505
specified master journal
group.
(Pairresync) operation failed
because the journal volumes
of the specified master
journal group were blocked.
0WCheck the status of the
journal volumes of the
The Add Pair (Paircreate)
operation or the Resume Pair
585916505
specified restore journal
group.
(Pairresync) operation failed
because the journal volumes
of the specified restore
journal group were blocked.
0WCheck the status of the
storage system. Retry the
The specified operation failed
because the subsystem was
585926505
operation after the storage
system has started.
being powered on or
powered off.
0WWait for a while, and refresh
the window. If this message
The storage system accepted
the request normally,
585936505
is displayed after a settinghowever the processing
operation, check whether therequires some time. If this
setting is reflected. When themessage is displayed after a
setting is not reflected, retry
the operation.
setting operation, refresh the
window and check the setting
to see if it is reflected. If the
setting is not reflected despite
refreshing the window, retry
the operation.
0WCheck the LUSE volume
configuration of the primary
The Paircreate operation
failed because the
585946505
data volume and the
secondary data volume.
configuration of the LUSE
volume was different between
284 Remote Web Console for Storage System Messages and Error Codes