HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 54 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
or the Universal Replicator for
Mainframe function of the
and call HP technical support
to confirm whether the XP
secondary subsystem does
not support external volumes.
Continuous Access Journal or
the Universal Replicator for
Mainframe function supports
external volumes.
5WCheck the DKCMAIN
microcode version of the
The Paircreate operation
failed because the XP
585016505
secondary storage systemContinuous Access Journal
and call HP technical supportfunction of the secondary
to confirm whether the XPsubsystem does not support
Data Retention Utility VMA. Continuous Access Journal
function supports Data
Retention Utility VMA.
5WConfirm the licensed capacity
of the Data Retention Utility
The operation failed because
the capacity of the secondary
585026505
of the secondary storagesubsystem has exceeded the
system. To perform thelicensed capacity of Data
Retention Utility. specified operation, purchase
a license key that allows you
to use a capacity larger than
the current capacity.
0WCheck the attribute and the
mirror status of the journal
group.
The specified operation failed
because of the attribute or the
mirror status of the journal
group.
585036505
5WIf this problem persists, call
HP technical support.
The operation failed. Refresh
the window and retry the
585046505
operation. If this problem
persists, call HP technical
support.
5WDisable the IO suppression
mode of the specified
The Add Pair (Paircreate)
operation failed because the
585086505
primary data volume on the
XP External Storage window.
IO suppression mode of the
specified primary data
volume was enabled.
0WCheck the mirror ID assigned
to the specified primary data
The Add Pair (Paircreate)
operation failed.
585106505
volume number
The combination of the
specified primary data
(LDKC:CU:LDEV) from the
secondary storage system,
volume number
and assign a mirror ID that is
(LDKC:CU:LDEV) and the
not used, and retry the
operation.
mirror ID is the same as the
combination specified from
another primary subsystem.
Check the mirror ID assigned
to the specified primary data
volume number
(LDKC:CU:LDEV) from the
secondary subsystem.
In the current microcode
version, specify a mirror ID
different from the ID used by
an existing pair, when you
create a pair by using the
same primary data volume
number (LDKC:CU:LDEV).
282 Remote Web Console for Storage System Messages and Error Codes