HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WCorrect the port information
or the PCB mode information.
The port information is
inconsistent with PCB mode
information.
11840003
6EThe configuration information
has been already changed.
You are trying to insert in the
linkage operation including
11850003
Check the settings andLUSE. (LDEV number is
request the setting of theinserted to the LDEV numbers
created in LUSE). configuration information
again.
6EThe configuration information
has been already changed.
In the linkage operation
including LUSE, the path is
11860003
Check the settings andspecified to other than the
top. request the setting of the
configuration information
again.
6EThe configuration information
has been already changed.
You cannot expand the LU
because the host mode of the
11870003
Check the settings andgroup with paths which are
request the setting of thedefined in the LU is
configuration information
again.
corresponding to online
LUSE.
6ECorrect the settings, and then
retry.
No information can be
changed about this external
11940003
port because the port has an
external volume.
6ECorrect the settings, and then
retry.
You cannot set high-speed
mode to a package including
an external port.
11970003
6EChange the parameter to a
path where the High Speed
The selection of High Speed
mode/MIX mode is invalid.
12010003
mode/MIX mode can be set,
and then retry the operation.
The specified port cannot be
changed to High Speed
mode/MIX mode.
6EThe configuration information
has been already changed.
High Speed mode/MIX mode
was specified. However,
12030003
Check the settings andthere are addresses to which
request the setting of theHigh Speed mode/MIX mode
configuration information
again.
cannot be set in the Fibre
Addresses of the specified
ports.
6EThe configuration information
has been changed already.
High Speed mode/MIX mode
was specified. However,
12040003
Check the settings, and
request the setting of the
there are topologies to which
High Speed mode/MIX mode
cannot be set in the
configuration information
again.
topologies of the specified
ports.
6EThe specified Port is for Fibre
XP Continuous Access. Delete
S-VOLs remain on the
Fibre-RCU port. This
13570003
a logical path, and then retry
the operation.
operation may cause a fatal
damage to the S-VOLs.
Please stop this operation. If
you want to continue this
operation, please remove the
S-VOLs from the RCU port
first.
Remote Web Console Error Codes 27