HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 54 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4iSee the Installation and Open
Platform sections in the
The emulation type of the
primary data volume is not
87466505
maintenance manual to checksupported by XP Continuous
if the device emulation of theAccess Journal or Universal
Replicator for Mainframe. primary data volume is
supported.
4iCheck if the secondary data
volume is online. If the
The specified secondary data
volume is online.
87496505
secondary data volume is
online, vary the volume
offline, and then retry the
operation. If the secondary
data volume is connected to
a VM system, vary the volume
offline from the VM system.
4ECheck the SSB log, and then
call HP technical support.
An internal error occurred.87536505
4WCheck the status of the cache
and the shared memory in the
One side of the cache or the
shared memory is blocked in
the primary storage system.
87576505
primary storage system.
Ensure that the cache and
shared memory is not
blocked.
4WCall HP technical support.An unexpected error
occurred in the primary
subsystem.
87586505
4WVerify that the secondary
data volume is not blocked,
The operation failed due to
one of the following reasons:
87646505
the restore journal group is
• The secondary data
volume was blocked.
registered, or the journal
volumes of the restore journal
• The restore journal group
was not registered.
group are not blocked,
respectively.
• The journal volumes of the
restore journal group were
blocked.
4iClick [OK] to finish
processing. Then wait a few
The cache in the primary
subsystem is automatically
recovering.
87706505
minutes and retry the
operation.
0WSelect another volume.The primary data volume is
already used by Compatible
XRC.
87766505
4WCheck the status of the cache
in the secondary storage
One side of the cache is
blocked in the secondary
subsystem.
87786505
system. Ensure that the cache
is not blocked.
0WCheck the port, ID, or LUN
settings in the secondary
The specified volume is not
defined in the secondary
87886505
storage system. See the Opensubsystem. Or, the device
Platform section in theemulation type of the
maintenance manual to checksecondary data volume is not
whether the device emulationsupported by remote copy via
the serial interface. type of the secondary data
volume is supported.
Remote Web Console Error Codes 261