HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 54 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4ECheck the serial number and
the controller ID of this remote
The serial number or the
controller ID of the remote
subsystem is incorrect.
87196505
storage system and already
registered remote storage
systems, and then specify the
correct values.
If the specified values are
correct, check the cable
connection of the remote
storage system. If the problem
persists, call HP technical
support.
4iReduce the number of
registered remote storage
The number of registered
remote subsystems already
87206505
systems, and then retry the
operation.
reached the maximum (that
is, 64).
4ECheck the path connections
between the local and the
Path creation has not finished
yet.
87216505
remote storage systems, and
then retry the operation.
4ECheck the path connections
between the local and the
Path creation failed.87226505
remote storage systems, and
then retry the operation.
4iAdd another path, or delete
all pairs on the remote
The Edit Path operation was
rejected because the
87236505
storage system. Then retry the
operation.
specified path is the last path
of some XP Continuous
Access pairs.
4iCheck the number of paths.The specified number of
paths is less than the
87246505
minimum number specified in
the DKC Option window.
4iDo either of the following to
recover from the error:
The number of minimum
paths exceeds the number of
normal paths.
87276505
• If the error code is 100c,
add normal paths, and
then set the minimum
number of paths.
• If the error code is 100d,
add normal paths, and
then delete paths.
Alternatively, reduce the
minimum number of paths,
and then delete paths.
4iDo either of the following to
recover from the error:
The number of minimum
paths exceeds the number of
normal paths.
87286505
• If the error code is 100c,
add normal paths, and
then set the minimum
number of paths.
• If the error code is 100d,
add normal paths, and
then delete paths.
Alternatively, reduce the
258 Remote Web Console for Storage System Messages and Error Codes