HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 54 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
operation on the primary
data volume.
4iCheck the number of paths.The specified number of
paths is less than the
87036505
minimum number of paths in
the DKC Option window.
4WCheck the path status in the
DKC Status window, and
then restore the paths.
The specified number of
paths is less than the
minimum number of paths in
87046505
the DKC Option window, due
to a communication error
between the local and the
remote subsystems.
4WCheck the CHA status on the
window. If the CHA is
The path could not be deleted
due to a communication error
87056505
blocked, replace the CHA,
and then retry the operation.
between the local and the
remote subsystems.
4iEnter the correct data.Parameter specified by XP
Continuous Access operation
is invalid.
87066505
4iRefresh the window, and
check the pair status. If
The pair status of the
secondary data volume is
incorrect.
87086505
possible, retry the operation
on the secondary data
volume.
4EReplace the channel adapter,
and then retry the operation.
XP Continuous Access
operation was rejected.
87096505
0WRefresh the window, and
check the pair status of the
The pair status of the
specified data volume is
incorrect.
87106505
pair. If the pair status can be
manipulated, retry the
operation.
4iCheck the port number, ID,
and LUN of the storage
system.
The specified parameter is
incorrect.
87116505
4EIf you are performing a path
operation, retry the operation
The operation was rejected
due to a FREEZE state.
87126505
after the FREEZE status is
released.
If you are performing a pair
operation, check the DKC
status, wait until the SCP time
elapses, and then retry the
operation.
4EExchange the port type after
deleting the group setting.
The port group already exists
on the specified port.
87136505
4ECall HP technical support.An internal error occurred.87146505
4EEnsure that the number of
paths is correct, and then
The number of paths is
incorrect.
87156505
retry the operation. If the
problem persists, call HP
technical support.
Remote Web Console Error Codes 257