HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 52 Error Codes — Part Code 6010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
want to continue this
operation?
0iTo output pair status into a
snapshot file, click [OK]. To
Are you sure you want to
export pair status?
91226010
cancel this operation, click
[Cancel].
0iTo continue the operation,
click [OK]. To cancel the
operation, click [Cancel].
This process may take up to
%d minutes. Do you want to
continue?
91246010
0WTo stop the operation, click
[OK]. To continue the
operation, click [Cancel].
Are you sure you want to
cancel the export?
91256010
0WTo terminate the script, click
[OK]. Otherwise, click
[Cancel].
The script is running now.
Are you sure you want to
terminate the script?
91266010
0iTo close the graphs, click
[OK]. Otherwise, click
[Cancel].
Are you sure you want to
close all active graphs?
91276010
0iClick [OK], and then specify
the correct volume.
The specified volume was not
found.
91286010
0iClick [OK] to continue
processing.
Recovered from the error that
occurred when copying
started.
91296010
0WFollow the instructions in the
message.
As a result of this operation,
you will not be able to re-start
91546010
ERASE R-VOL operation. To
delete the pair forcibly, try
again with Force option.
0iClick [OK].The history file has been
updated. Select the OK
91556010
button to display the history
logs from the beginning.
0WFollow the instructions in the
message.
WARNING: Destination
volume of specified volume
93006010
pair may contain some
inconsistency, because
volume copy is not completed
yet. Full volume initialization
is required before re-using it.
0WFollow the instructions in the
message.
WARNING: Through this
operation, M-VOL status will
93016010
be changed to SMPL status
forcibly, but R-VOL status will
not be changed. If you do
this operation, change the
R-VOL status to SMPL later.
0WSet the port to RCP before
registering RCU. Moreover,
There are no RCP ports.93026010
set up the correct range of
CU numbers to which the RCP
port is applied.
Remote Web Console Error Codes 249