HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 52 Error Codes — Part Code 6010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WSpecify the correct CU
number.
The specified CU number is
incorrect. Specify the correct
CU number.
51406010
0WSpecify the correct device
number.
The specified LDEV number
is incorrect. Specify the
correct LDEV number.
51416010
0WSpecify the correct group
number.
The specified GID is
incorrect. Specify the correct
GID.
51426010
0WSpecify the correct LUN.The specified LUN is
incorrect. Specify the correct
LUN.
51436010
0WCheck the entered values,
and then specify correct
values.
Some of the entered values
are incorrect. Check the
values and then specify
correct values.
51446010
2ECall HP technical support.An error occurred in the client
logic.
70606010
2ECall HP technical support.An error occurred in the client
logic.
73016010
2ECall HP technical support.An error occurred in the client
logic.
73026010
2ECall HP technical support.An error occurred in the client
logic.
73036010
2EIf this problem persists, call
HP technical support.
An error occurred during
processing. If this problem
74406010
persists, call HP technical
support.
5WClick [Refresh], and retry.The system cannot apply the
new configuration. Do you
want to refresh?
81016010
0WSuspend the specified pair,
and perform the operation to
resume the pair.
An error occurred when
copying started.
89286010
5WFollow the instructions in the
message.
Exchange the channel cable
connections after
confirmation of the port type.
90066010
0WConfirm that the R-VOLs to
specify are varied offline.
Confirm that the R-VOLs to
specify are varied off-line.
90076010
0iClick [OK].SIMs of XP Continuous
Access are cleared.
90086010
0iClick [OK].The export is complete.90096010
5WClick [Yes] to continue
processing. After processing
The Port Setting process has
not completed. Do you want
to continue for other ports?
90216010
is complete, reset the port
that is not in operation.
0WCheck the contents of the
main and remote volumes. If
WARNING: Initial copy
mode None is selected for
90226010
246 Remote Web Console for Storage System Messages and Error Codes