HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
You cannot do any of the
following to the same volume:
The following settings are
invalid.
• Specify the volume as a
command device and
1. Set command device +
Release command device
security
disable command device
security on the volume.
2. Release command device
+ Set command device
security
The error does not occur
normally because it
• Specify the volume as a
non-command device and
enable command device
security on the volume.
cannot be modified in the
window. In the unlikely
event that this error
occurs, contact HP
technical support.
6EThe configuration information
has been already changed.
There are no host groups
where the WWN will be
registered.
11250003
Check the settings and
request the setting of the
configuration information
again.
6ECorrect the specified
contents, and request again.
A volume set as a command
device cannot be used as a
11260003
component of a LUSE volume.
Select another volume.
2ECHA high-speed mode is
specified to unmounted CHA.
An error occurred. If this
problem persists, call HP
technical support.
11270003
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
2EA request has been made to
change to a channel speed
An error occurred. If this
problem persists, call HP
technical support.
11280003
that the Fibre PCB does not
support it. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
2EWhen the WWN is
registered in LUN Manager,
An error occurred. If this
problem persists, call HP
technical support.
11290003
the number of WWNs you
can register is exceeded. The
error does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
6ECorrect the specified
contents, and request again.
You cannot specify the
default nickname when
11300003
setting the nickname of a host
group or a host.
24 Remote Web Console for Storage System Messages and Error Codes