HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
3ECall HP technical support.An error occurred during SVP
processing. If this problem
570056005
persists, call HP technical
support.
5iSelect another volume, and
retry the operation.
A pair cannot be created
because the specified M-VOL
583196005
is used by XP Continuous
Access Journal or Universal
Replicator for Mainframe.
0WIf the Add Pair (Paircreate)
operation failed:
The operation failed because
the specified R-VOL was used
by XP Continuous Access
583206005
• When the RCU runs on the
2DC configuration in
Journal or Universal
Replicator for Mainframe.
which the XP Continuous
Access Journal
cooperates, wait for a
while until the pair status
of the XP Continuous
Access Journal becomes
PAIR, and then retry the
operation.
• When the RCU runs on the
configuration other than
the 2DC configuration in
which the XP Continuous
Access Journal
cooperates, specify
another volume for R-VOL,
and then retry the
operation.
If the Pairresync operation
failed, resume the XP
Continuous Access Journal
pair volume first.
5iSelect another volume, and
retry the operation.
The pair cannot be created
because the specified M-VOL
583216005
is a LUSE volume that is set
across the multiple CLPRs.
5iSelect another volume, and
retry the operation.
The pair cannot be created
because the specified R-VOL
583226005
is a LUSE volume that is set
across the multiple CLPRs.
5iTo create a pair by using a
volume without VMA, you
A pair cannot be created,
because you tried to create
583576005
must only use volumes withouta volume pair formed with a
VMA. To create a pair byvolume to which VMA is set
using a volume with VMA,by Data Retention Utility and
a volume without VMA. you must only use volumes
with VMA.
5iWait a few seconds, and
then retry the operation.
A pair cannot be created,
because the set processing of
583586005
VMA that is used for Data
Retention Utility has not been
completed for the specified
P-VOL.
Remote Web Console Error Codes 235