HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
CT groups of asynchronous
pairs that you can register in
SLPR exceeds the limit.
4iCheck the settings, and then
retry the operation.
The coexistence of volumes
that are in the different CLPRs
89856005
is not allowed within one CT
group.
4iVerify that both MCU and
RCU support the serial
interface.
Cannot create a pair,
because the serial interface
is not supported by either the
MCU or the RCU.
89866005
4iVerify that both MCU and
RCU support LUSE volumes
Cannot create a pair,
because LUSE volumes
89876005
that consist of volumes from
different CUs.
consisting of volumes from
different CUs are not
supported by either the MCU
or the RCU.
4iVerify that both MCU and
RCU support LUSE volumes
Cannot create a pair,
because LUSE volumes
89886005
consisting of volumes that
differ in capacity.
consisting of volumes that
differ in capacity are not
supported by either the MCU
or the RCU.
4iCheck the version of the
microcode of the storage
system.
The specified M-VOL is a
volume used by FlashCopy
Mirroring V2.
89896005
If the microcode of the
storage system supports the
The operation failed because
of one of the following
reasons. interface between FlashCopy
Mirroring V2 and M-VOL of
• The current microcode
cannot use a volume used
TrueCopy for Mainframe,
and then check the setting of
by FlashCopy Mirroring
V2 as an M-VOL.
Difference Management of
the specified volume. Also,
• Cylinder was set for the
Difference Management
of the M-VOL.
check the setting of Initial
Copy when you have
executed Add Pair operation.
• The Add Pair operation
was executed specifying
None for Initial Copy.
If microcode version or the
setting does not match the
above description, check
whether the specified volume
• The M-VOL belonged to
Sync Group.
belongs to Sync Group from
Business Continuity Manager.
4iSpecify the volume that can
be used to create a pair, and
then retry the operation.
A pair cannot be created,
because the specified R-VOL
is used for Compatible
FlashCopy V2.
89906005
5ESpecify the port assigned to
SLPR0.
The attribute of the port
assigned to SLPRs except
552306005
SLPR0 can only be changed
to Target.
3ESelect another window. To
set this function, contact the
storage administrator.
This function cannot be used
by the storage partition
administrator.
565246005
234 Remote Web Console for Storage System Messages and Error Codes