HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4WVerify whether the
parameters of M-VOL, for
At least one of the following
is invalid:
89456005
example, CU number, port,
• M-VOL parameters (CU
number, Port, GID, LUN)
GID and LUN, are supported
with the RCU microcode
program version or not.
• SSID or CU number of the
RCU
If you create a pair by using
a LUSE volume, verify
• R-VOL parameters (Port,
GID, LUN)
whether or not two or more
CU numbers coexist in P-VOL
and S-VOL.
Specify RCUs of CU Free
when two or more CU
numbers coexist in P-VOL or
S-VOL.
Then, retry the operation with
the correct parameters.
4iRelease the setting of the
external volume, and retry the
operation.
The external volume that is
mapped to an internal
volume is connected to the
port.
89476005
4iStop I/O operations, and
retry.
The specified port is receiving
I/O requests.
89486005
4ECall HP technical support.An internal error occurred.89496005
4ECall HP technical support.An internal error occurred.89506005
4iCheck the status of the
specified R-VOL.
The operation failed because
the specified R-VOL was used
for Flex Copy XP.
89736005
4iCheck the status of the
specified R-VOL.
Failed to create a pair,
because the specified R-VOL
89756005
is path-defined from the iSCSI
port.
4iCheck the status of the
specified M-VOL.
A pair cannot be created,
because the specified M-VOL
is an external volume.
89766005
4iCheck the status of the
specified R-VOL.
A pair cannot be created,
because the specified R-VOL
is an external volume.
89776005
4iConfirm the licensed capacity
Volume Retention Manager
The operation failed because
the licensed capacity of
89806005
on the RCU side. To executeVolume Retention Manager
this operation, purchase aon the RCU side was
exceeded. license key that allows you to
use a larger capacity.
4iSpecify the volume that can
be used to create a pair, and
then retry the operation.
You cannot create a pair,
because the specified M-VOL
is a command device.
89826005
4iSpecify the volume that can
be used to create a pair, and
then retry the operation.
You cannot create a pair,
because the specified R-VOL
is a command device.
89836005
4ECheck the settings, and then
retry the operation.
You cannot create a new
pair, because the number of
89846005
Remote Web Console Error Codes 233