HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
the pair status, and if the
operation is permitted retry.
4iCheck if the specified Port,
GID, LUN, CU, or LDEV
The Port, GID, LUN, CU, or
LDEV number of the specified
volume is incorrect.
87116005
number exists in the storage
system.
4EThe operation was rejected
due to a FREEZE state.
87126005 1. If this was a path
operation retry after the
problem has been fixed.
2. If this was a pair
operation, retry after the
paths have been
recovered. Two ways to
recover paths are:
a. Execute ESTPATH from
the host console, or
b. First delete the paths
from the SVP, and then
re-add them.
4EThe port type could not be
changed because the port
The port group already exists
on the specified port.
87136005
group was set in the specified
package. Delete the group
setting, and then change the
port type.
4ECall HP technical support.An internal error occurred.87146005
4EThe specified number of
paths is not within the
Invalid number of paths.87156005
acceptable path range of 0
to 4. Verify the number of
paths and retry the operation.
4EThe specified logical address
must be either 00 or 01.
Invalid Destination Link
Address.
87176005
Check the logical address
and retry the operation.
4iThe specified link address
and port are already in use.
The specified logical path
already exists.
87186005
Check all existing logical
path addresses, and specify
another link address or RCP
port.
4ECheck the serial number,
SSID, link address and
Invalid RCU serial number,
SSID, Link Address or
Controller ID.
87196005
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, contact HP
technical support.
4iA maximum of four RCUs are
permitted, and that many
already exist.
Too many RCUs. (Four RCUs
are the maximum)
87206005
4ECheck the path connections
between the MCU and the
Path not completely
established.
87216005
Remote Web Console Error Codes 213