HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 49 Error Codes — Part Code 5310 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
port has reached the
maximum for the ports being
target at the same time, and
then retry the operation.
set as monitoring target at the
same time.
Table 50 Error Codes — Part Code 6005
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
50136005
persists, call HP technical
support.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
50996005
persists, call HP technical
support.
4iRefresh the window.This function does not support
the specified port.
51456005
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
60006005
persists, call HP technical
support.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
60126005
persists, call HP technical
support.
3WIf the same problem persists
despite retrying, call HP
technical support.
The SVP is busy. Please wait
for a while, and then retry the
operation.
60236005
4ERetry the operation. If you get
the same message again,
A time-out error occurred.80006005
reboot the computer. If
necessary, call HP technical
support.
4ERetry the operation. If you get
the same message again,
A time-out error occurred.80016005
reboot the computer. If
necessary, call HP technical
support.
4ERetry the operation. If you get
the same message again,
A time-out error occurred.81006005
reboot the computer. If
necessary, call HP technical
support.
0WWait for awhile, refresh the
window, and confirm the pair
The storage system accepted
the request normally,
81046005
status has been changed
properly.
however the processing
requires some time. Wait for
If the pair status is not
changed after refreshing the
awhile, and then refresh the
window and confirm the pair
status has been changed
properly.
window, check the MCU or
RCU configuration and the
Remote Web Console Error Codes 211