HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
cannot be processed in this
agent. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
2ELUN is invalid. (The specified
value is not in the
An error occurred. If this
problem persists, call HP
technical support.
10200003
specification.) The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
2EThe specified volume does
not exist. (You have specified
An error occurred. If this
problem persists, call HP
technical support.
10210003
wrong CU#:LDEV#.) Or the
LDEV (exclusively for
mainframe) cannot be
processed in this agent. The
error does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
2EHost mode is invalid. (The
specified value is not in the
An error occurred. If this
problem persists, call HP
technical support.
10220003
specification.) The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
2EIf this problem persists, call
HP technical support.
An error occurred. If this
problem persists, call HP
technical support.
10230003
2EFibre topology information is
invalid. (The specified value
An error occurred. If this
problem persists, call HP
technical support.
10240003
is not in the specification.)
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
6EThe configuration information
has been already changed.
The specified LU path does
not exist.
10250003
Check the settings and
request the setting of the
configuration information
again.
2EThe specified value of the
command device setting is
The specified value of the
command device setting is
invalid. Check the setting.
10270003
invalid. (The specified value
is not in the specification.)
The error does not occur
Remote Web Console Error Codes 19