HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 3 Error Codes — Part Code 0003
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe configuration information
has been already changed.
You are trying to set multiple
paths to the same volume
from one group.
10030003
Check the settings, and
request the setting of the
configuration information
again.
6EThe configuration information
has been changed already.
Multiple volumes are
specified to a single port,
group or LUN combination.
10040003
Check the settings, and
request the setting of the
configuration information
again.
6EThe configuration information
has been already changed.
The emulation type of the
volumes combined into a
10090003
Check the settings andLUSE volume is not for open
systems. request the setting of the
configuration information
again.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
10100003
persists, call HP technical
support.
2EThe volume that links as an
expanded LU extends over
An error occurred. If this
problem persists, call HP
technical support.
10110003
CU#. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
6EThe configuration information
has been already changed.
LU path is set to a volume
which links as an expanded
LU.
10120003
Check the settings and
request the setting of the
configuration information
again.
2EThe emulation type of a
volume that links as an
The emulation types of the
volumes combined into a
10130003
expanded LU is not the same.LUSE volume are not the
same. The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
6EThe configuration information
has been already changed.
LU path is set to the releasing
expanded LU. (You need to
10150003
Check the settings andrelease the expanded LU and
path at the same time.) request the setting of the
configuration information
again.
2EThe specified port does not
exist. You have specified a
An error occurred. If this
problem persists, call HP
technical support.
10180003
wrong port number. Or the
specified port type
(exclusively for mainframe)
18 Remote Web Console for Storage System Messages and Error Codes