HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 34 Error Codes — Part Code 3005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ECheck the current
configuration of association.
The number of XP Thin
Provisioning volumes that can
687483005
be associated with a single
pool has exceeded the
maximum.
6EWait for a while, and then
retry the operation.
The disk storage system is
executing the processing to
687513005
release the association,
inside.
Wait for awhile, and then
retry the operation.
6EWhen the pool cannot be
restored, do the following:
• Wait for a while, click
[Refresh] or [Refresh All]
on the File menu of the
Remote Web Console
window, and then check
the pool status in the Pool
window.
If this problem persists,
see the troubleshooting
section of the HP
XP24000/XP20000 Thin
Provisioning Software
User Guide to solve this
problem.
Restoration of the pool has
failed. Pool cannot be
restored when:
687973005
• processing takes time,
because blocked parts
exist in the storage system.
• the Pool-VOL is blocked.
6EWhen the pool cannot be
deleted, do the following:
Deletion of the pool has
failed. Pool cannot be
deleted when:
687983005
• Check the installation
status of the V-VOL• V-VOL management area
is not initialized. management area if the
V-VOL management area
is not initialized.
• V-VOL management area
is not installed.
• Check the installation
status of the V-VOL
• XP Snapshot pair still
remains in the pool.
management area if the
• P-VOL still remains in the
pool.
V-VOL management area
is not installed.
• the Pool-VOL in the pool
is blocked.
• Delete the XP Snapshot
pair if the pair still
remains in the pool.
• the processing to release
the association of XP Thin
• Delete the XP Snapshot
pair if the P-VOL still
remains in the pool.
Provisioning volume is
being executed
• the process to convert the
allocation method of pool
is being executed.
• Check the status of the
pool-VOL in the pool, and
restore the pool-VOL if it
is blocked.
• Click Refresh or Refresh
All on the File menu of the
Remote Web Console
window, confirm that the
amount of usage in the
pool is zero in the Pool
Remote Web Console Error Codes 143