HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 27 Error Codes — Part Code 1010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
setting of the configuration
information again.
5WCorrect the specified content,
and retry.
The specified LDEVs and free
LUNs should be the same
number.
50101010
5WYou cannot specify any more.The number of LU paths in
use has already reached the
50401010
maximum (2,048 in a Fibre
Channel environment).
5WReduce the number, and
retry.
The number of LUNs in use
has already reached the
50411010
maximum number of LUNs
that can be specified per host
group (2,048 in a Fibre
Channel environment).
5WReduce the number, and
retry.
The number of LUNs in use
has already reached the
50421010
maximum number of LUNs
that can be specified per port
(2,048 in a Fibre Channel
environment).
5WReduce the number, and
retry.
The selected number of LDEVs
exceeds the number of free
LUNs.
50431010
5WCheck the content of the
operation.
The specified LUN had been
set.
50501010
3ECheck the content of the
operation.
The selected LUN is not a
command device.
50511010
5WCheck the content of the
operation.
Select the LUN that is already
assigned.
50521010
5WCheck the content of the
operation.
No port is specified.50531010
5WCheck the content of the
operation.
You must map at least one
path to the command device.
50541010
5WCheck the content of the
operation.
The specified LUN does not
exist in the system.
50561010
5WCheck the content of the
operation.
No LUN is specified.50571010
5WCheck the content of the
operation.
The fibre address is
duplicated.
50591010
5WFollow the correct operation
procedure.
LUN or CU:LDEV is repeated.50701010
5WFollow the correct operation
procedure.
Path setup cannot be
performed because the copy
50711010
source is not an open-system
volume.
5WCheck the content of the
operation.
The specified LUN is the last
path to the command device.
Release the command device.
50991010
Remote Web Console Error Codes 113