HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ECheck the setting.The specified volume cannot
be set as a command device,
19271005
because it is being used as a
quorum disk.
6WSet Host Mode Option 60 to
OFF, and then execute
Addition or deletion of paths
for LUN0 cannot be done
19281005
addition or deletion of paths
for LUN0.
because Host Mode Option
60 is set to ON. Also, setting
change of Host Mode Option
60 and path change
(addition or deletion) for
LUN0 cannot be done at the
same time. Execute the
changing operations
separately.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
20051005
persists, call HP technical
support.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
20091005
persists, call HP technical
support.
6ECheck if the host is
performing I/O operations on
the target path or volume.
The LDEV is being used by
the host, or an error occurred
during SVP processing.
20101005
Recovery processing may
take about 1 minute. Wait for
a while.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
20131005
persists, call HP technical
support.
6EA communication error
occurs. If the error occurs
An error occurred while
connecting to the subsystem.
20151005
after retrying, call HP
technical support.
Wait for a while, and then
retry the operation.
3ERetry the operation later.Communication busy. Retry
later.
20321005
6EThe host is mounted or the
device is reserved. Unmount
Processing is disabled
because the host is mounted
or the device is reserved.
20821005
the host and cancel
reservation of the device. If
the host is an AIX host,
unmount the host, and
execute the varyoffvg
command.
2ECheck the DKC status and the
current status of the
The subsystem status is
invalid. Call HP technical
support.
20831005
configuration setting. If
necessary, re-execute the
setting operation.
2ECheck the DKC status and the
current status of the
The subsystem status is
invalid. Call HP technical
support.
20841005
configuration setting. If
108 Remote Web Console for Storage System Messages and Error Codes