HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 26 Error Codes Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ENo more host groups can be
set, because the number of
No more host groups can be
set, because the number of
11311005
host groups has reached thehost groups has reached the
maximum (254) that can bemaximum (254) that can be
set in a port. set in a port. Reduce the
number of host groups, and
then retry the operation.
6EThe configuration information
has been already changed.
Failed to set the WWN
because the number of
11321005
Check the settings, and
request the setting of the
WWNs exceeds the
maximum that can be set in
a port.
configuration information
again.
6EThe configuration information
has been already changed.
Failed to set the host mode
because the number of host
11331005
Check the settings, and
request the setting of the
modes exceeds the maximum
that can be set in a port.
configuration information
again.
6EThe configuration information
has been already changed.
Failed to set the path because
the number of paths exceeds
11341005
Check the settings, and
request the setting of the
the maximum that can be set
in a port.
configuration information
again.
2EWhen PORT information
(Fibre Address/Fibre
An error occurred. If this
problem persists, call HP
technical support.
11351005
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
2EWhen CHA high-speed mode
is set, multiple change
An error occurred. If this
problem persists, call HP
technical support.
11361005
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
6EThe configuration information
has been already changed.
Failed to form a LUSE volume
because the number of LUSE
11371005
Check the settings, and
request the setting of the
volumes exceeds the
maximum that can be set in
a disk array subsystem.
configuration information
again.
2EAn error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
11381005
Remote Web Console Error Codes 103