HP XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, November 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EHost mode is invalid. (The
specified value is not in the
An error occurred. If this
problem persists, call HP
technical support.
10221005
specification.) The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
2EIf this problem persists, call
HP technical support.
An error occurred. If this
problem persists, call HP
technical support.
10231005
2EFibre topology information is
invalid. (The specified value
An error occurred. If this
problem persists, call HP
technical support.
10241005
is not in the specification.)
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
6EThe configuration information
has been already changed.
The specified LU path does
not exist.
10251005
Check the settings, and
request the setting of the
configuration information
again.
6EThe configuration information
has been already changed.
The number of volumes you
intend to combine into a
10281005
Check the settings, and
request the setting of the
LUSE volume exceeds the
maximum.
configuration information
again.
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
10291005
persists, call HP technical
support.
6EThe configuration information
has been already changed.
The following volumes cannot
be specified when you
10501005
Check the settings, and
request the setting of the
change expanded LU
configurations:
• Volumes reserved by Auto
LUN
configuration information
again.
2EYou are trying to perform
LUN Manager operation for
An error occurred. If this
problem persists, call HP
technical support.
10591005
non-Fibre port. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
6EFirst, add paths, and then
click Apply. Next, turn off the
Security Switch Off operation
and path adding operation
10611005
security switch, and then click
Apply.
cannot be performed
simultaneously. Check the
100 Remote Web Console for Storage System Messages and Error Codes