HP XP24000/XP20000 for FlashCopy Mirroring Software User Guide (T5240-96012, November 2011)

Table 63 Parameters for the FCQUERY Command (Version 2) (continued)
DescriptionValueParameter
Displays all of the detailed relationship
information.
ALL
Specifies the number of relationships to
display.
The number of relationships
Displays the specified number of
detailed relationship information.
Specifies the CCHH number of the
starting address.
CCHH numberSTARTADDR
Use this parameter when the number of
relationships is specified in the
SHOWRELS parameter.
The FCQUERY command can be used to display information, including the attributes set to the
devices specified by DEVN and the number of Version 2 relationships established with the specified
devices.
(page 123) shows an example of the FCQUERY command. This example requests the information
on the device numbered 4202 to be displayed.
Figure 82 FCQUERY Command Description
FCQUERY DVEN(X'4202')
(page 123) shows the information displayed as a result of executing the FCQUERY command
described in (page 123). Definition of each displayed item is explained in (page 123).
Figure 83 FCQUERY Command Execution Result
ANTF0090IF CQUERY Formatted
DEVN SSID LSS CCA CU SERIAL ACT MAX XC PC CC RV SE SEQNUM
4202 0102 02 02 2105 000000045029 1 1000 N N N N NN 00000000
(page 123) shows the information displayed by the FCQUERY Command (Version 2).
Table 64 Information Displayed by the FCQUERY Command (Version 2)
DefinitionDisplayed contentDisplayed item
Device number recognized by the hostDEVN
Storage system numberSSID
CU numberLSS
Device numberCCA
DKC emulation typeCU
Serial numberSERIAL
Number of active Version 2 relationships. See (page 125).ACT
Maximum number of pairs that can be created with the device specified by DEVN.MAX
Volume specified by DEVN is in one of the following statuses:SXC
• S-VOL of the Compatible XRC pair
• At-Time Split volume for ShadowImage for Mainframe (online)
1
Viewing Information for a Version 2 Relationship 123