HP XP24000/XP20000 for FlashCopy Mirroring Software User Guide (T5240-96012, November 2011)

Table 62 Parameters for the ANTRQST Macro Command in Version 2 (continued)
DescriptionValueParameterCommand
specified, the relationships
on all tracks are withdrawn.
Specifies the device number
(device address) of the
YESTGTUCB
T-VOL on which you want to
perform the FCWITHDRAW
command. To specify this
number, use the TDEVN
parameter. YES is the default
setting.
Specifies the DKC device
number (LDEV number) of the
NO
T-VOL on which you want to
perform the FCWITHDRAW
command. To specify this
number, use the TGTSERIAL,
TGTLSS, and TGTDVC
parameters instead of
TDEVN.
Specifies the DKC device
number of the T-VOL on
Serial numberTGTSERIAL
which you want to perform
the FCWITHDRAW command.
Use this parameter when the
TGTUCB parameter is NO.
Specifies the LSS of the
T-VOL on which you want to
LSSTGTLSS
perform the FCWITHDRAW
command. Use this
parameter when the
TGTUCB parameter is NO.
Specifies the CCA of the
T-VOL on which you want to
CCATGTDVC
perform the FCWITHDRAW
command. Use this
parameter when the
TGTUCB parameter is NO.
Viewing Information for a Version 2 Relationship
To see the status of Version 2 relationships, use the PPRC TSO FCQUERY,ICKDSF, or ANTRQST
Macro command.
Viewing Relationship Status of Version 2 Using the TSO Command
(page 122) describes the parameters you can use with the FCQUERY command.
Table 63 Parameters for the FCQUERY Command (Version 2)
DescriptionValueParameter
Specify the number (device address) of
the Version 2 volume for which you
want to see the status.
Device number.DEVN
Displays the relationship information.NOSHOWRELS
If the SHOWRELS parameter is not
specified, NO is set by default.
122 Performing Version 2 Operations