HP StorageWorks XP24000/XP20000 Thin Provisioning Software User Guide (T5227-96015, May 2011)

Table 16 Error Code and Error Contents When Operating XP RAID Manager (continued)
SolutionError ContentsError Code (SSB2)Error Code (SSB1)
When increasing capacity,
make sure that the ratio of free
space in the pool to free space
in the V-VOL is not below the
V-VOL threshold. For details,
see the conditions for
increasing the V-VOL capacity
in “Increasing V-VOL Capacity”
(page 67).
Because the ratio of the free
space capacity of the pool to
the free space capacity of the
V-VOL was less than the
V-VOL threshold, the
operation was rejected.
0xaf2d0xb96b
Wait until formatting of the
specified volume is finished, or
see “Using XP Thin Provisioning
with Other Products (page 18)
and confirm whether the V-VOL
is used with the application
that the V-VOL capacity cannot
be increased.
Because the specified V-VOL
was used by another
application or was being
formatted, the operation was
rejected.
0xaf2e0xb96b
Re-execute the operation after
the microcode is replaced.
Because the V-VOL capacity
was increased when the
microcode was replaced, the
operation was rejected.
0xaf2f0xb96b
Calling HP Technical Support
If you need to call HP technical support, make sure to provide as much information about the
problem as possible, including:
The circumstances surrounding the error or failure
The exact content of any error messages displayed on the host systems
The exact content of any error messages displayed by Remote Web Console
The Remote Web Console configuration information (use the FD Dump Tool)
The service information messages (SIMs), including reference codes and severity levels,
displayed by Remote Web Console
For worldwide technical support information, see the HP support website:
http://www.hp.com/support
86 Troubleshooting