HP StorageWorks XP24000/XP20000 Remote Web Console Users Guide (AE131-96067, July 2009)

Figure 6 Temporary Files Settings Dialog Box (for JRE 6.0)
Configuring Communications over only IPv6
Internet Protocol Version 6 (IPv6) can also be used for communications between a Remote Web
Console computer and an SVP. To communicate with only IPv6, both a Remote Web Console computer
and an SVP must be configured to use only IPv6 for communications. For information on how to
configure an SVP, contact HP Technical Support (see “Calling HP Technical Support” on page 160).
NOTE:
To use IPv4 and IPv6 for communications, do not apply the setting described in this section. In this
case, IPv4 has a priority over IPv6.
This section explains how to configure a Remote Web Console computer when its operating system
is Windows Vista or Solaris 10. For other operating systems, contact the appropriate developers.
For Windows Vista: To configure a computer to use only IPv6 for communications:
1. Select the Windows Control Panel > Network and Sharing Center > Manage Network Connections.
2. Select and right-click a network that connects an SVP, and click Properties in the pop-up menu.
3. Click Continue if the User Account Control dialog box appears.
The Networking dialog box displays properties of the selected network (see Figure 7 on page 35).
4. Clear the Internet Protocol Version 4 (TCP/IPv4) check box in the list.
5. Click OK to close the dialog box.
Installation Requirements and Procedures34