HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 10 Error Codes — Part Code 0110 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iTo close the window, click
[OK]. To not close the
window, click [Cancel].
The value that is under setup
is not reflected yet. Do you
want to exit?
91050110
0iTo change the mode, click
[OK]. To not change the
mode, click [Cancel].
The value that is under setup
is not reflected yet. Do you
want to change the mode?
91060110
0iTo continue processing, click
[OK]. To stop processing,
click [Cancel].
The value that is under setup
is not reflected yet. Do you
want to continue the
operation?
91070110
5iTo update the status
immediately, click [Refresh].
The installation status of
program products has been
changed. To update the
status immediately, select the
[Refresh] button.
550450110
1EContact the storage
administrator and request to
allocate the license of SLPR.
There are no valid program
products. Contact the storage
administrator and request to
allocate the license of SLPR.
556040110
1EInstall the supported version
of JRE.
The unsupported JRE version
is used. Install the supported
version of JRE, and then retry
the operation.
565030110
7EReturn to the Modify mode
and change the configuration
again.
Modify mode released due
to inactivity. Another user or
service engineer may have
changed the configuration
while the Modify mode was
released. Get back to the
Modify mode and change the
configuration again. Set the
“RMI time-out period for
Modify” by using the “Set
Env.” dialog box located on
the Control Panel of the
Remote Web Console to
change the time-out period
for Modify mode.
565580110
2ELog off from Remote Web
Console. Then log on to
Remote Web Console again
and check whether
configuration changes have
been made correctly.
If configuration changes have
been made correctly, there is
no problem.
If configuration changes have
been made incorrectly, retry
the operation.
An error occurred regarding
screen display. Log off from
Remote Web Console. After
that, please log on to Remote
Web Console again and
check whether configuration
changes have been made
correctly.
570110110
1EIf this problem persists, call
HP technical support.
The configuration information
is incorrect. Call HP technical
support.
585800110
Remote Web Console Error Codes 53