HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 67 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2ECHA high-speed mode is
specified to an unmounted
CHA. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
An error occurred. If this
problem persists, call HP
technical support.
11278105
2EA request has been made to
change to a channel speed
change is requested, but
Fibre PCB does not support
it. The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
An error occurred. If this
problem persists, call HP
technical support.
11288105
6ECorrect the specified
contents, and request again.
The specified name is the
same as the system default
name. Change the name.
11308105
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the host group
because the number of host
groups exceeds the maximum
that can be set in a port.
11318105
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
11328105
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
11338105
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
11348105
Remote Web Console Error Codes 401