HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 63 Error Codes — Part Code 7010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WApply the data in the Preview
List. To stop the transaction,
click [OK] and continue the
operation.
The data has been changed.
If you select another tab
(page), the settings will be
discarded. Are you sure you
want to continue?
51217010
0WGo on to the next operation.No data has been changed.51227010
0WCheck the password.The password is invalid.51237010
0WMultiple volumes cannot be
processed in the operation.
Process one volume at a time.
You cannot select more than
one operation at a time.
51247010
0WSelect the target volume.No target volume is selected.51257010
0WYou cannot create L2 pair for
the specified P-VOL. Delete
the created L2 pair, and retry
the operation.
You cannot create another L2
pair, because the number of
L2 pairs exceeds the
maximum.
51267010
0iSelect the other MU number.The specified MU number is
invalid. Select another MU
number.
51277010
0iYou cannot create L1 pair for
the specified P-VOL. Delete
the created L1 pair, and retry
the operation.
The number of L1 pairs
exceeds the maximum.
65047010
0iYou cannot create L2 pair for
the specified P-VOL. Delete
the created L2 pair, and retry
the operation.
The number of L2 pairs
exceeds the maximum.
65057010
0ECall HP technical support.Unregistered error code.73107010
0WWait a few seconds, and
retry the operation. If the
error occurs after retrying,
call HP technical support.
The settings could not be
applied.
73117010
0ECall HP technical support.The password could not be
acquired.
73127010
0ECall HP technical support.Error details not available.73137010
2EIf this problem persists call HP
technical support.
An error occurred during
processing. If this problem
persists, call HP technical
support.
74407010
0ECall HP technical support.An internal logic
contradiction occurred.
85347010
0ECheck the error code in the
Preview list.
Some settings could not be
applied normally. See the
error code.
86587010
5iMount the required PCB, and
then retry the operation.
The PCB required for this
operation is not mounted.
Check the subsystem
configuration.
86597010
Remote Web Console Error Codes 367