HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 61 Error Codes — Part Code 7005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iDelete the XP Continuous
Access pair.
The Reverse Copy command
has been rejected, because
the S-VOL is shared as the
S-VOL of a XP Continuous
Access pair.
86477005
0iCheck the specified volume
number.
The boot device and the
P-VOL do not match in the
Paircreate command.
86487005
0iCheck the specified volume
number.
Because the boot device is
the S-VOL in the Pairsplit-S
command, the flag does not
match.
86497005
0iCheck the target volume
number.
The boot device and the
P-VOL do not match in the
Paircreate, Pairresync, or
Pairsplit-S command.
86507005
0iCheck the contents, and retry.The SSID is invalid.86517005
0iCheck the target volume
number.
The boot device is not a
P-VOL nor S-VOL.
86527005
0iCheck the target volume
number.
Because the boot device is
the P-VOL in the Pairsplit-S
command, the flag does not
match.
86537005
0iCheck the target volume
number.
Boot device and S-VOL do
not match in Paircreate,
Pairresync, or Pairsplit-S
instructions.
86547005
0iCheck the contents, and retry.An invalid secondary SSID is
specified for the Paircreate or
Pairresync command.
86557005
0iCheck the contents, and retry.The secondary SSID specified
for the pairsplit-S or pairsplit
command is invalid.
86567005
5ECall HP technical support.The Swap&Freeze option
cannot be specified, because
mode 80 is on.
86577005
0iMatch the number of volumes
composing the LUSE volume
you intend to specify as the
P-VOL and the number of
volumes composing the LUSE
volume you intend to specify
as the S-VOL, and then retry
the operation.
The number of volumes
composing the LUSE volume
specified as the P-VOL does
not match the number of
volumes composing the LUSE
volume specified as the
S-VOL.
86707005
0iCorrect the MU number, and
then retry the operation.
The specified MU number is
not less than or equal to 2.
86957005
0iWait until L1 pair becomes
PSUS status, and execute the
operation to L2 pair.
Because a L1 pair is not
PSUS, you cannot operate to
L2.
89207005
Remote Web Console Error Codes 357