HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ECorrect the specified
contents, and request again.
You cannot specify the
default nickname when
setting the nickname of a host
group or a host.
11300003
6ENo more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. Reduce the
number of host groups, and
then retry the operation.
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port.
11310003
6EThe configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
11320003
6EThe configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
11330003
6EThe configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
11340003
2EWhen PORT information
(Fibre Address/Fibre
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
11350003
2EWhen CHA high-speed mode
is set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
11360003
6EThe configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to form a LUSE volume
because the number of LUSE
volumes exceeds the
maximum that can be set in
a disk array subsystem.
11370003
26 Remote Web Console for Storage System Messages and Error Codes