HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 52 Error Codes — Part Code 6010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2ECall HP technical support.An error occurred in the client
logic.
73036010
2EIf this problem persists, call
HP technical support.
An error occurred during
processing. If this problem
persists, call HP technical
support.
74406010
5WClick [Refresh], and retry.The system cannot apply the
new configuration. Do you
want to refresh?
81016010
0WSuspend the specified pair,
and perform the operation to
resume the pair.
An error occurred when
copying started.
89286010
5WFollow the instructions in the
message.
Exchange the channel cable
connections after
confirmation of the port type.
90066010
0WConfirm that the R-VOLs to
specify are varied offline.
Confirm that the R-VOLs to
specify are varied off-line.
90076010
0iClick [OK].SIMs of XP Continuous
Access are cleared.
90086010
0iClick [OK].The export is complete.90096010
5WClick [Yes] to continue
processing. After processing
is complete, reset the port
that is not in operation.
The Port Setting process has
not completed. Do you want
to continue for other ports?
90216010
0WCheck the contents of the
main and remote volumes. If
the contents match, click
[OK]. If not, click [Cancel].
WARNING: Initial copy
mode None is selected for
some volume pairs. Are you
sure that the M-VOL and the
R-VOL of these pairs are
already synchronized?
90226010
5WFollow the instructions in the
message.
Are you sure you want to
exchange the specified ports?
Confirm the associated
channel paths are off-line.
90246010
5WTo continue the operation,
click [OK]. Otherwise, click
[Cancel].
Are you sure you want to
switch the ports? If the remote
copy paths exist on the ports,
delete them beforehand.
90256010
5WTo continue the operation,
click [OK]. Otherwise, click
[Cancel].
Are you sure you want to
switch the ports? If any
remote copy paths exist on
the ports, delete them
beforehand. Also, to avoid
the switching operation from
being reported as a failure,
confirm first that a message
prompting you to change the
channel cable connections is
displayed, and then perform
the necessary changes.
90266010
256 Remote Web Console for Storage System Messages and Error Codes