HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)
Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EThe setting method of
command device/command
device security is incorrect.
The following settings are
invalid.
1. Set command device +
Release command device
security
2. Release command device
+ Set command device
security
The error does not occur
normally because it
cannot be modified in the
window. In the unlikely
event that this error
occurs, contact HP
technical support.
The command device setting
and the command device
security setting are incorrect.
You cannot do any of the
following to the same volume:
• Specify the volume as a
command device and
disable command device
security on the volume.
• Specify the volume as a
non-command device and
enable command device
security on the volume.
11240003
6EThe configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
There are no host groups
where the WWN will be
registered.
11250003
6ECorrect the specified
contents, and request again.
A volume set as a command
device cannot be used as a
component of a LUSE volume.
Select another volume.
11260003
2ECHA high-speed mode is
specified to unmounted CHA.
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
An error occurred. If this
problem persists, call HP
technical support.
11270003
2EA request has been made to
change to a channel speed
that the Fibre PCB does not
support it. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
An error occurred. If this
problem persists, call HP
technical support.
11280003
2EWhen the WWN is
registered in LUN Manager,
the number of WWNs you
can register is exceeded. The
error does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
An error occurred. If this
problem persists, call HP
technical support.
11290003
Remote Web Console Error Codes 25