HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4ECall HP technical support.An internal error occurred.87146005
4EThe specified number of
paths is not within the
acceptable path range of 0
to 4. Verify the number of
paths and retry the operation.
Invalid number of paths.87156005
4EThe specified logical address
must be either 00 or 01.
Check the logical address
and retry the operation.
Invalid Destination Link
Address.
87176005
4iThe specified link address
and port are already in use.
Check all existing logical
path addresses, and specify
another link address or RCP
port.
The specified logical path
already exists.
87186005
4ECheck the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, contact HP
technical support.
Invalid RCU serial number,
SSID, Link Address or
Controller ID.
87196005
4iA maximum of four RCUs are
permitted, and that many
already exist.
Too many RCUs. (Four RCUs
are the maximum)
87206005
4ECheck the path connections
between the MCU and the
RCU, and then retry the
operation.
Path not completely
established.
87216005
4ECheck the path connections
between the MCU and the
RCU, and then retry the
operation.
Failure during path creation.87226005
4iAdd another path, or delete
all pairs on the RCU. Then
retry the operation.
The Edit Path operation was
rejected because the
specified path is the last path
of some XP Continuous
Access pairs.
87236005
4iThe specified number of
paths is less than the
minimum number of paths
specified on the RCU Option
window.
Specified number of paths is
less than the minimum
specified on RCU Option
screen.
87246005
4iThe version of the microcode
on the storage system does
not support the specified
function or operation. Call HP
technical support.
Current microprogram
version does not support the
specified operation.
87256005
4iAdd the normal paths, and
then set the minimum number
of paths.
The number of minimum
paths exceeds the number of
normal paths.
87276005
Remote Web Console Error Codes 221