HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4WCheck the paths status and
reestablish the paths.
The specified number of
paths is less than the
minimum number of paths on
the RCU option screen due to
a communication error
between the MCU and the
RCU.
87046005
4WEither a communication error
occurred between the MCU
and the RCU, or the CHA has
become blocked. Call HP
technical support.
The path could not be deleted
due to a communication error
between MCU and RCU.
87056005
4iA parameter specified by the
XP Continuous Access
operation is invalid. For
example, the R-VOL that is
specified could already be in
use as the R-VOL of another
XP Continuous Access pair.
Parameter specified by XP
Continuous Access operation
is invalid.
87066005
4iCheck the pair status for XP
Continuous Access. If the
requested R-VOL is in a
permissible status, retry the
operation.
The pair status of the R-VOL
is not valid.
87086005
4EAll channel adapters are not
active for XP Continuous
Access. Call HP technical
support.
XP Continuous Access
operation was rejected.
87096005
4iThe pair status does not
permit this operation. Verify
the pair status, and if the
operation is permitted retry.
The pair status of the
specified volume is not valid.
87106005
4iCheck if the specified Port,
GID, LUN, CU, or LDEV
number exists in the storage
system.
The Port, GID, LUN, CU, or
LDEV number of the specified
volume is incorrect.
87116005
4E1. If this was a path
operation retry after the
problem has been fixed.
2. If this was a pair
operation, retry after the
paths have been
recovered. Two ways to
recover paths are:
a. Execute ESTPATH from
the host console, or
b. First delete the paths
from the SVP, and then
re-add them.
The operation was rejected
due to a FREEZE state.
87126005
4EThe port type could not be
changed because the port
group was set in the specified
package. Delete the group
setting, and then change the
port type.
The port group already exists
on the specified port.
87136005
220 Remote Web Console for Storage System Messages and Error Codes