HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 50 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EIf this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
60126005
3WIf the same problem persists
despite retrying, call HP
technical support.
The SVP is busy. Please wait
for a while, and then retry the
operation.
60236005
4ERetry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
A time-out error occurred.80006005
4ERetry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
A time-out error occurred.80016005
4ERetry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
A time-out error occurred.81006005
0WWait for awhile, refresh the
window, and confirm the pair
status has been changed
properly.
If the pair status is not
changed after refreshing the
window, check the MCU or
RCU configuration and the
and the condition of the paths
between the MCU and RCU.
The storage system accepted
the request normally,
however the processing
requires some time. Wait for
awhile, and then refresh the
window and confirm the pair
status has been changed
properly.
If the pair status is not
changed after refreshing the
window, check the MCU or
RCU and the condition of the
paths between the MCU and
RCU.
81046005
4iRetry the operation.Retry operation.87006005
4iA logical path does not exist
between the MCU and the
RCU. Check the path status
on RCU Status dialog box,
and reestablish the paths with
Edit Path.
Logical Path between the
MCU and the RCU is not
active.
87016005
4iRefresh the window, and
check whether the specified
volume is a M-VOL.
The specified volume is not
an M-VOL.
87026005
4iThe number of paths is less
than the minimum number
specified on the RCU Option
dialog box. Check the
number of paths, establish the
minimum number of paths,
and retry the operation.
The specified number of Paths
is less than the Minimum
number of Paths on RCU
Option screen.
87036005
Remote Web Console Error Codes 219