HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 27 Error Codes — Part Code 1010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
5WCheck the content of the
operation.
No port is specified.50531010
5WCheck the content of the
operation.
You must map at least one
path to the command device.
50541010
5WCheck the content of the
operation.
The specified LUN does not
exist in the system.
50561010
5WCheck the content of the
operation.
No LUN is specified.50571010
5WCheck the content of the
operation.
The fibre address is
duplicated.
50591010
5WFollow the correct operation
procedure.
LUN or CU:LDEV is repeated.50701010
5WFollow the correct operation
procedure.
Path setup cannot be
performed because the copy
source is not an open-system
volume.
50711010
5WCheck the content of the
operation.
The specified LUN is the last
path to the command device.
Release the command device.
50991010
5WCorrect the settings, and then
retry.
You entered the wrong item.58221010
5WCorrect the settings, and then
retry.
It is not updated.58231010
5WRelease the reserved attribute
of the target volume by using
Data Retention Utility.
The specified volume cannot
be manipulated because it is
reserved by RAID Manager.
58671010
0WCorrect the mode of the
target group.
The host mode is invalid.
Specify a correct host mode.
65091010
2ECall HP technical support.An error occurred in the client
logic.
70601010
0iTo continue processing, click
[OK]. Otherwise, click
[Cancel].
LUN security for the specified
command device will be
released. Do you want to
continue?
90121010
0iThe LUN will be specified as
a command device. Do you
want to continue?
90131010
0iThe LUN will not be specified
as a command device. Do
you want to continue?
90141010
0iTo change the parameter in
High-Speed mode/MIX
mode, click [OK]. Otherwise,
click [Cancel].
The port of a PCB in High
Speed mode/MIX mode is
selected. When changing the
parameter of topology or the
parameter of host speed, the
change will be applied to the
PCB in High Speed
mode/MIX mode. Are you
sure you want to continue this
operation?
90151010
118 Remote Web Console for Storage System Messages and Error Codes