HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EIf this problem persists call HP
technical support.
An error occurred. If this
problem persists call HP
technical support.
11821005
0WCorrect the port information
or the PCB mode information.
The port information is
inconsistent with PCB mode
information.
11831005
0WCorrect the port information
or the PCB mode information.
The port information is
inconsistent with PCB mode
information.
11841005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
You are trying to insert in the
linkage operation including
LUSE. (LDEV number is
inserted to the LDEV numbers
created in LUSE).
11851005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
In the linkage operation
including LUSE, the path is
specified to other than the
top.
11861005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
You cannot expand the LU
because the host mode of the
group with paths which are
defined in the LU is
corresponding to online
LUSE.
11871005
6ECorrect the settings, and then
retry the operation.
To define a path to the
volume from an iSCSI port,
the volume must be
read/write-enabled and also
usable as an S-VOL
(secondary volume).
11901005
6ECorrect the settings, and then
retry.
No information can be
changed about this external
port because the port has an
external volume.
11941005
6ECorrect the settings, and then
retry.
You cannot set high-speed
mode to a package including
an external port.
11971005
6ECorrect the settings, and then
retry.
Since a path is defined to an
external LU, you cannot set
high-speed mode.
11981005
6ECheck the setting.The path cannot be set to the
specified volume because the
volume is not an
open-systems volume.
11991005
6EChange the parameter to a
path where the High Speed
mode/MIX mode can be set,
and then retry the operation.
The selection of High Speed
mode/MIX mode is invalid.
The specified port cannot be
changed to High Speed
mode/MIX mode.
12011005
Remote Web Console Error Codes 109