HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EWhen PORT information
(Fibre Address/Fibre
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
11351005
2EWhen CHA high-speed mode
is set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
11361005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to form a LUSE volume
because the number of LUSE
volumes exceeds the
maximum that can be set in
a disk array subsystem.
11371005
2EAn error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
11381005
2ERelease the Port Group
setting.
Because the Port Group
setting is done, it is
impossible to change.
Release the Port Group
setting.
11401005
6ECorrect settings, and then
retry.
The volume cannot be
configured as a command
device because the volume
does not have Read/Write
attribute.
11701005
6ECorrect the settings, and then
retry.
The specified host ID is
already registered.
11741005
6ECorrect the settings, and then
retry.
The specified host is already
registered.
11771005
6ECorrect the settings, and then
retry.
An incorrect host name was
specified.
11781005
2EIf this problem persists call HP
technical support.
An error occurred. If this
problem persists call HP
technical support.
11801005
6WCorrect the specification, and
then retry the operation.
The specified path cannot be
added, because the volume
is used by a XP Continuous
Access pair.
11811005
108 Remote Web Console for Storage System Messages and Error Codes