HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2ECHA high-speed mode is
specified to unmounted CHA.
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
An error occurred. If this
problem persists, call HP
technical support.
11271005
2EChannel speed change is
requested, but Fibre PCB
does not support it. The error
does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
An error occurred. If this
problem persists, call HP
technical support.
11281005
6ECorrect the specified contents,
and request again.
You cannot specify the
default nickname when
setting the nickname of a host
group or a host.
11301005
6ENo more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. Reduce the
number of host groups, and
then retry the operation.
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port.
11311005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
11321005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
11331005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
11341005
Remote Web Console Error Codes 107