HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96086, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The following volumes cannot
be specified when you
change expanded LU
configurations:
• Volumes reserved by Auto
LUN
10501005
2EYou are trying to perform
LUN Manager operation for
non-Fibre port. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
10591005
6EFirst, add paths, and then
click Apply. Next, turn off the
security switch, and then click
Apply.
Security Switch Off operation
and path adding operation
cannot be performed
simultaneously. Check the
current configuration and
then make settings again.
10611005
6ECorrect the specified contents,
and request the setting of the
configuration information
again.
The specified WWN is
already in use. Specify
another WWN.
10631005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
You are trying to register the
same WWN as the already
registered one. Check the
settings and request the
setting of the configuration
information again.
10641005
6ECorrect the specified contents,
and request the setting of the
configuration information
again.
The specified host name or
the host group name is
already registered. (The host
name and the host group
name cannot be the same.)
10651005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
WWN number, which is not
registered, is specified.
(When deleting, or changing)
10661005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
You are trying to register the
same host group number as
the already registered one.
10671005
6EThe configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The specified host group has
not been registered.
10681005
Remote Web Console Error Codes 105