HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96014, September 2007)

Part
Code
Error
Number
Error Messag e
Recommended Ac tion
Severity
Level
Failure
Level
8105 1108
The following volumes
cannot
be specified when
you change command
device configurations:
•
Volumes reserved by
Auto L UN
•
Volumes other than the
open-system volumes
(including unmounted
volumes)
Command device setting
is
requested for Reserve
volume of Auto LUN. Or
it
is requested for volumes
other
than open volumes
(including uninstalled
volumes). The error does
not
occur normally because
it
is guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical support.
E
6
8105 1110
You cannot use following
characters for the name:
"\ /: , ; *? <> |
You cannot use spaces
for the first and the last
characters in the name.
Remove the prohibited
characters from the
nickname.
W
5
8105
1111
An error occurred. If this
problem persists, please call
technical support.
Anicknam
eisnot specified
when the
configuration
change of L UN-Security is
requested. The er ror does
not
occur normally because
it
is guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical support.
E
2
8105 1116
An error occurred. If this
problem persists, please call
technical support.
You have not specified
the value when registering
WWN,orzeroisset as
theWWN value. Theerror
does not
occur normally
because it is guarded in
the screen. In the unlikely
eventthatthiserror occurs,
contact technical suppor t.
E
2
8105 1123
Command device security
cannot beset to thespecified
volume because the volume
is not a command
device.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
8105
1124
An error occurred. If this
problem persists, please call
technical support.
The command device setting
and the command device
secur ity setting are incorrect.
You cannot do any of
the
following to the same
volume:
•
Specify the volume as
a
command device and
disable command device
security on the volume.
•
Specify the volume as
a
non-command device
T
he
setting method of
command device/command
device security is incorrect.
The following set tings are
invalid. *Set command
device + Release command
device security
*Release command device
+
Set command device
security
It
does not occur normally
because it is guarded in
the screen. In the unlikely
eventthatthiserror occurs,
contact technical suppor t.
E
2
XP24000/XP20000 Remote Web Console Error Codes
345