HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96014, September 2007)

• The word R-VOL in TrueCopy for Mainframe messages is equivalent to S-VOL in Continuous
Access messages.
• Part code: The ID of the application that issued the message. In
“Sample Message Window (Information Level Message)” on page 13 the pa rt cod e is 11 0.
• Message number: Decimal num ber within the range of 0000 to 99999. In
“Sample Message Window (Information Level Message)” on page 13 the message number is
9102.
Note: If Remote We b Console starts and displays the following message, see the co de and number the
(YYYY ZZZZZ) represents. A check box may be indicated in the message window. If you check the check
box, note that the m essage will not be displayed until you login again.
A network error occurred, the server is not ready, or an error occurred
in the server. (YYYY ZZZZZ)
Remote Console-Remote Web Console Error Codes
Note: To find solutions to the HP Remote Web Console for storage system errors, see the tables of this
manual, or the Troubleshooting chapter in the user guides for the program products causing the errors.
The tables list the error codes and error messages for Remote Web Console and provides recommended
action for the error conditions.
Note: In some cases, the Recommended Action column may be blank. In these cir cumstances, the user
should take actions based on instructions provided in the error message and based on what the user is
trying to accomplish. The tables also provide the severity level and failure level of the error conditions.
Severity Levels. The severity levels for the error codes are:
• i: Information
• E:Error
• W: Warning
• N: The ser ver is unable to a ccept the request from Remote Web Console. One possible cause is
that some processisinprogressatthe server. Thismessage does notindicateanerror.
Failure Levels. The failure levels for the error codes are:
• 0:No Error
• 1: Select MSG OK to end forcibly
• 2:All Refresh or Exit is valid only
• 3: All Refresh, Refresh, or Exit is valid and the buttons, other than the buttons of the functions in
which the error occurred, are valid.
• 4: To m ake refresh possible
• 5: No status change
• 6: No change with refreshing automatically
• 7: Remote Web Console is automatically switched to view mode. If necessary, change the
mode
to Modify.
Note: The iSCSI function is planned for future support.
Table 2 Error Codes — Part Code 0001
Part
Code
Error
Number
Error Message
Recommended Action
Severity
Level
Failure
Level
0001 1000
An error occurred during
SVP p rocessing. If this
problem persists, please call
technical support.
If this problem persists call
technical support.
E
2
14
HP
StorageWorks XP Remote Web Console for Storage System Messages and Error Codes